PeopleSoft : Job Code Full Sync Process (Integration Broker)

Activate Data Publish Rules In Source

• Go to Enterprise Components > Integration Definitions >Full Data Publish Rule
• Search for "JOBCODE_FULLSYNC” message.
• If the rule is Inactive then make the status to Active and save the rule.

Activate Outbound Routing In Soruce      

• Go to People Tools >> Integration Broker >> Integration Setup >> Service Operations
• Search for “JOBCODE_FULLSYNC” Service Operation
•  Navigate to the Routings tab.
•  Select the outbound routing between "Source" to "Target"
•  If the Routing is Inactive then click on ‘Activate Selected Routings’ button.

     Activate Inbound Routing In Destination

•     Go to PeopleTools > Integration Broker > Integration Setup > Service Operations
•       Search for “JOBCODE_FULLSYNC” Service Operation
•       Navigate to the Routings tab.    
•       Select the inbound routing between "Source" to "Target"   
•       If the Routing is Inactive the click on 'Activate Selected Routings' button.  
• 
  

    Run “Full Table Data Publish” Process In Source

       

•       
  Go to Enterprise Components > Integration Definitions > Initiate Processes > Full Data Publish
•      
  Provide run control id in search page.
•      
  In run control page select process frequency as “Once”
•       
  Select Message Name “JOBCODE_FULLSYNC”
•       
  Click on “Run” button

•       Select EOP_PUBLISHT (Full Table Data Publish) process
•       Click “Ok” button.

 

    

    Verify IB Messages Were Posted In Source

•      Go to PeopleTools > Integration Broker > Service Operations Monitor > Monitoring > Asynchronous Services
•      In Monitor Overview tab select queue level as Pub Con, Group By Service Operation
•      Select proper time period
•      Verify messages for JOBCODE_FULLSYNC service operation

   

•      If messages are in Error or Timeout state then click on message count.
•      You will navigate to Publication Contracts tab on the same page.
•      Click on Details link for timed out or error message
•      Find out the root cause.

       Verify IB Messages Were Received In Destination

•     Go to PeopleTools > Integration Broker > Service Operations Monitor > Monitoring > Asynchronous Services
•       In Monitor Overview tab select queue level as Sub Con, Group By Service Operation  
•       Select proper time period
•       Verify messages for JOBCODE_FULLSYNC service operation

     Note: If messages were not received then bounce pubsub servers.